Popis: Separátory KingAir řady KAKIT Mikro filtrace. Jsou určeny k odstraňování pevných nečistot, vody, oleje, aerosolů, uhlovodíků, pachů ze systému stlačeného vzduchu. Provedení zařízení umožňuje efektivní odstranění >99.9999% vody a ostatních nečistot až do velikosti 0,01 mikronu. KAKIT3 se skládá s řady plast PA, PC, PM (max. 10 bar) KA - 300PA řada plastových separátorů s označením PA parametrově shodná s řadou STANDARD. KAF - 300PC olejový filtr s označením PC odstraňuje do velikosti < 0,01mg/M3 KAF - 300PM mikro filtr s označením PM odstraňuje nečistoty do velikosti 0,01 µm na 99.9987% KAKIT4 se skládá s řady plast PA, PC, PD, PM (max.10 bar) KA - 300PA řada plastových separátorů s označením PA parametrově shodná s řadou STANDARD. KAF - 300PC olejový filtr s označením PC odstraňuje do velikosti < 0,01mg/M3 KAF - 300PD absorpční filtr. Snižuje tlak rosného bodu o - 22⁰C KAF - 300PM mikro filtr s označením PM odstraňuje nečistoty do velikosti 0,01 µm na 99.9987% Sestavy jsou vybaveny KAR948 regulátorem talku. Připojení závit ½ Aplikace: Automobilový průmysl, chemický a petrochemický průmysl, plastikářský průmysl, elektronická výroba, potravinářství a nápoje, lakýrnictví atd. Certifikace: ISO 12500 (IUTA), SGS, PED (SEP), BACTERIA TEST Instalace: Sestava je určena jako koncová před zdrojem užívání. KAKIT je instalován např. před lakovací pistole do boxu. Údržba: KA - 300PA automatický odvod separátu. KAF - 300PC odvod ventilkem na nádobě. Výměna po uplynutí životnosti. Ruční odpouštění při naplnění spodního okraje nádoby. KAF - 300PD odvod ventilkem na nádobě. Výměna po uplynutí životnosti. Ruční odpouštění při naplnění spodního okraje nádoby. KAF - 300PM odvod ventilkem na nádobě. Výměna po uplynutí životnosti. Ruční odpouštění při naplnění spodního okraje nádoby. Údržba musí být provedena dle návodu. V případě problému je třeba vyhledat odborný servis CMP Trade. Technická specifikace řady KAKIT: Provozní tlak: 1 bar až 10 bar Provozní teplota: 1 C až 50 C Ztráta tlaku KAKIT3 : viz poslední strana Ztráta tlaku KAKIT4: viz poslední strana Description: KingAir Separators KAKIT Series - Microfiltration. They are designed to remove solid impurities, water, oil, aerosols, hydrocarbons, odors from the compressed air system. The design of the device allows an effective removal of> 99.9999% of water and other impurities up to 0.01 microns. KAKIT3 consists of plastic - PA, PC, PM (max. 10 bar) KA - 300PA - a series of plastic separators with PA designation identical to the STANDARD series. KAF - 300PC - Oil filter with PC label removes up to <0.01mg / M3 KAF-300PM - PM micro filter removes impurities up to 0.01 μm to 99.9987% KAKIT4 consists of plastic - PA, PC, PD, PM (max.10 bar) KA - 300PA - a series of plastic separators with PA designation identical to the STANDARD series. KAF - 300PC - Oil filter with PC label removes up to <0.01mg / M3 KAF - 300PD - Absorption filter. Decreases dew point pressure by -22 C KAF-300PM - PM micro filter removes impurities up to 0.01 μm to 99.9987% Assemblies are equipped with KAR948 - talcum controller. Thread connection ½ " Application: Automotive, chemical and petrochemical, plastics, electronics, food and beverages, varnishing etc. Certification: ISO 12500 (IUTA), SGS, PED (SEP), BACTERIA TEST Installation: The assembly is intended as a terminal before the source of use. KAKIT is installed, for example, in front of the spray gun in the box. Maintenance: KA - 300PA - automatic separation of the separator. KAF - 300PC - drain valve on the vessel. Replacement after the service life. Manual discharging when filling the lower edge of the container. KAF - 300PD - drain valve on the vessel. Replacement after the service life. Manual discharging when filling the bottom edge of the container. KAF - 300PM - drain valve on the vessel. Replacement after the service life. Manual discharging when filling the bottom edge of the container. Maintenance must be carried out in accordance with the instructions. In the event of a problem, consult CMP Trade. Technical specifications of the KAKIT series: Operating pressure: 1 bar up 10 bar Operating temperature: 1 C to 50 C Loss of KAKIT3 pressure: see last page Loss of pressure KAKIT4: see last page
Materiál KAKIT Material of KAKIT Popis vnějšího obalu: Cover description: Popis části (description) Vnější obal (cover) Manipulační úchyt (handling elements) Propojovací materiál (connection material) Redukční ventil - regulátor KAR-948 (regulator) Váha (weight) Materiál (material) plast + průhledný PC (plastic + transparent polycarbonate) Nerez (stainless steel) spojka s vnějším válcovým závitem - nerez ½ (stainless) hliník + plast připojení ½ (aluminium + plastic) 2,85 kg Popis vnitřního vybavení: Internal equipment: Popis části (description) Separátor KA - 300PA (separator) Olejový filtr KA 300PC (carbon filter) Absorpční filtr KA -300PD (desiccant filter) Částicový filtr KAF -300PM (micro filter) Váha (weight) Materiál (material) plast + ABS (plastic + ABS) uhlíkové vlákno (carbon fiber) kuličky oxid hlinitý (activated alumina) duté vlákno (hollow fiber) 3,35 kg KAKIT 3 KAKIT4
27 55 28 12 TECHNICKÝ LIST řada mikrofitrace KAKIT3 a KAKIT4 Demontovaná horní část obalu : vstup (IN) výstup (OUT) Disassembled upper cover: Tělo KAKITU: Body of KAKIT: Demontáž šroubů 4 ks Release bolts 4 pcs 4 x Ø 4 vstup 1/2" 75 výstup 1/2" 15 56 4 x Ø 4 79 závit na tělo 80
Ochranné tělo nádoby: Protection cover: Nádoba pro separát s ručním ventilkem pro odpouštění: Drenage vessel with manual valve for drain:
Redukční ventil - regulátor KAR-948 Pressure regulator KAR-948:
4 8 103 4 5 8 TECHNICKÝ LIST řada mikrofitrace KAKIT3 a KAKIT4 Vnitřní vložka s průhledného plastu. V horní části plastový závit opatrně dotahovat. Těsnící O-kroužek Náplň dle druhu filtru Usazen uvnitř odpouštěcí nádoby. Inner liner with transparent plastic. At the top of the plastic thread - carefully tighten. O-ring. Refill cartridge according to filter type. Set up inside the discharge tank. 55 1/8" 20 15 KA 300PA : separace vody (water separator) 27 50 Automatický odvaděč kondenzátu (autodrain) KAP 300C: separace oleje (oil filtration)
KAP 300D: separace vzdušné vlhkosti o - 22⁰C (desiccant filter) KAP 300M: separace nečistot (microfilter) spodní pohled (bottom view) Vstup do filtrační vložky Inlet filter Výstup z filtrační vložky Outlet from filter
KAKIT3 KAKIT4
CMP Trade, s.r.o. Za Olomouckou 4184/14 CZ-79601 Prostějov info@cmptrade.cz www.cmptrade.cz